Categories

Modifying the Teensy 3.5 and 3.6 for ARM SWD debugging

Posted on Thursday, May 4th, 2017 in ARM, techniques by DP

teensy-3-6

Erich Styger @ mcuoneclipse.com writes:

Looking for a small, inexpensive ($25-30) ARM development board (say 120-180 MHz ARM Cortex-M4 with FPU, 512kB-1MB of FLASH and 256 KByte of RAM? Then have a look at the Teensy 3.5 and Teensy 3.6 by PJRC/Paul Stoffregen
The only problem? it is not possible to debug it :-(. At least not in the traditional sense. This article is about how to change the board to use it with any normal SWD debugging tool e.g. Eclipse and the Segger J-Link :-).

More details at MCU on Eclipse homepage.

This entry was posted on Thursday, May 4th, 2017 at 11:42 pm and is filed under ARM, techniques. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • gant: They still have a couple of the more expensive (but still considerably cheap) 5S-I-S01 in stock...
  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!