Magic Mote MSP430G2553 wireless sensor node with NRF24L01+ module

Posted on Wednesday, April 12th, 2017 in MSP430, wireless by DP


Tom from Magic Smoke writes:

This is my first time designing a PCB for MSP430. I really like the NRF24L01+ booster pack but I would like something smaller to use for remote temperature sensors. With that in mind I’ve designed a 24.5 x 50 mm PCB (2 on a 5×5 cm prototype) featuring MSP430G2553 and an adapter for a 8-pin NRF24L01+ module using essentially the same pinout, with the intention of using the Spirilis library. There’s a jack socket to connect a 1-wire sensor (e.g. DS18B20), a 4-pin header to connect a temperature/humidity sensor (SHT22 or similar), a programming header that gives serial access, and 3 other general purpose I/O pins.

More details at Magic Smoke blog.

This entry was posted on Wednesday, April 12th, 2017 at 11:22 pm and is filed under MSP430, wireless. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Stephen Tinius: Thank you.
  • KH: Ah, the site sells boards, that's the reason. At least it's a XC6SL9 board that does not cost an arm and a leg, though it...
  • Max: While I understand this is more educational than practical in nature, I prefer my edutainment a lot more firmly grounded in economic reality. Sure, you...
  • KH: Using an alkaline coin cell down to 1.0V or under is a very bad idea anyway, unless you as the designer or manufacturer don't care...
  • KH: Farnell says TS1001 is no longer stocked. Not on RS. Digikey says it's obsolete. That said, there are a lot of nanoamp-class parts on sale...