Categories

USBuddy: USB development tool

Posted on Saturday, May 21st, 2016 in tools, USB by DP

USBuddy-600

Jakub has designed and built a USB breakout board with current monitor, an open hardware tool – USBuddy:

Do you sometimes develop with USB? I do. So I need to access data lines, bus voltage and I’d like to easily monitor the current too. I made myself a small companion (43.5 mm × 22.5 mm, 9.5 g) to do that. Just a simple breakout board with one connector in and one out. And a little extra to make things easier. I call it USBuddy.

Project info at Kaktus Circuits blog. It’s also up on Tindie.

This entry was posted on Saturday, May 21st, 2016 at 2:45 am and is filed under tools, USB. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please