Categories

Automatic monitor brightness controller

Posted on Monday, April 4th, 2016 in DIY, PIC, USB by DP

26189508935_1c9ac089ab_z

Dilshan Jayakody writes:

This is an automatic “monitor brightness controller” based on environmental light conditions. This system use USB port base sensor unit to measure the light level and control monitor brightness accordingly. We design this system to reduce the eye stress by matching the monitor brightness with environmental lighting.

Project info at Dilshan¬†Jayakody’s blog.

This entry was posted on Monday, April 4th, 2016 at 4:00 pm and is filed under DIY, PIC, USB. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Automatic monitor brightness controller”

  1. KH says:

    Personally, I think ambient back lighting is a better solution.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please