Categories

Mini CW Keyer / QRSS beacon v1.1

Posted on Tuesday, March 1st, 2016 in PCBs by DP

keyer-600

Marko Pavlin has designed a PCB for the CW keyer, he writes:

I designed dedicated PCB for the CW keyer. The project is very similar to the version made on prototyping board.

Here are the updates:
– I added relay and optocoupler for PTT control
– The “CW melody” selection pins have three jumpers for 8 combinations
– The audio output has 1W audio amplifier and RC at the PWM output (work to do in software driver for audio generator)
– USB connector is microUSB female which can be used with any phone charger

Project info at Mare & Gal Electronics site.

This entry was posted on Tuesday, March 1st, 2016 at 12:44 am and is filed under PCBs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: So Romanians use old ICs too, a bit reminiscent of Dilshan's projects. I'm vaguely disappointed by the liberal use of float data and float calculations....
  • Max: This is of course no "0-30V" supply - the single-supply standard LM723 schematic can't go all the way down to zero, which is why I...
  • KH: A power-off current draw of 4mA for the Sony A6000 is a defect, product recall territory. It hits the camera battery with unacceptable wear and...
  • Olav Storstrøm: Please add 9-pin D-sub RJ45 and RJ12 connectors! Thanks!
  • KH: Hydroponics is like home automation. Every year you have folks who start projects like these and think it will take off and become a big...