Categories

Open-source SWD programming adapter

Posted on Monday, February 29th, 2016 in open source by DP

protoprog-stlink-600x400

Ethan Zonca from Protofusion writes, “After making the switch from AVR to STM32 microcontrollers, I redesigned my old 6-pin ICSP pogo-programming adapter for SWD. The new design allows programming with pogo pins or a small pin header soldered to the pogo pads for debugging, all with the same cable. The footprint uses surface mount pads only, so it can be placed on even the most compact board layouts.”

More info at  Protofusion.org project page.

This entry was posted on Monday, February 29th, 2016 at 2:39 pm and is filed under open source. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: So Romanians use old ICs too, a bit reminiscent of Dilshan's projects. I'm vaguely disappointed by the liberal use of float data and float calculations....
  • Max: This is of course no "0-30V" supply - the single-supply standard LM723 schematic can't go all the way down to zero, which is why I...
  • KH: A power-off current draw of 4mA for the Sony A6000 is a defect, product recall territory. It hits the camera battery with unacceptable wear and...
  • Olav Storstrøm: Please add 9-pin D-sub RJ45 and RJ12 connectors! Thanks!
  • KH: Hydroponics is like home automation. Every year you have folks who start projects like these and think it will take off and become a big...