Categories

App note: Designing with the EZ-USB FX3 Slave FIFO Interface

Posted on Sunday, February 21st, 2016 in app notes by DP

apps1

Designing with the EZ-USB FX3 Slave FIFO Interface application note (PDF!) from Cypress:

AN65974 describes the synchronous Slave FIFO interface of EZ-USB FX3. The hardware interface and configuration settings for the FLAGs are described in detail with examples. The application note includes references to GPIF™ II Designer to make the Slave FIFO interface easy to design with. Two complete design examples are provided to demonstrate how you can use the synchronous Slave FIFO to interface an FPGA to FX3.

This entry was posted on Sunday, February 21st, 2016 at 2:39 am and is filed under app notes. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please