Install a pressurized water system on your car bumper

Posted on Friday, July 31st, 2015 in how-to by DP


Want to add this on your car? Check out Eddie Zarick‘s video on how to install a pressurized water system on your car bumper:

A step by step guide to me cutting up my 15′ Wrangler and installing some running water from my stock rear bumper using a 12v RV pump. Check it out!

Via Make.

Check out the video after the break.

This entry was posted on Friday, July 31st, 2015 at 7:00 pm and is filed under how-to. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Cyk: Well, this is an application that I'd solve with an Android smartphone. Used Moto G phones can be found on Ebay for ~€30, and thanks...
  • Noy: Yuuup
  • KH: I guess this is a failed attempt at making a pass/fail cable tester out of discrete ICs. A single pass/fail LED is not that useful....
  • Max: Considering it only seems to test that all wires conduct, I'm not sure what exactly does this show you that 7 LEDs each powered through...
  • David: Please