Categories

NExuS project

Posted on Wednesday, July 29th, 2015 in Arduino by DP

IMG_20150708_204853

Adam over at Maniacal Labs has written up documentation on his NExuS weekend project:

My main desires for this build was that the NES look completely stock and unchanged from the front and that original, unmodified, NES gamepads worked via the original gamepad ports. Fortunately, this turned out not to be too bad. First, I needed all the extra parts that would allow me to break out power, network, and video for the Nexus player, and to hook up some extra peripherals. Some I already had lying around, some I had to order but for all parts, these are the exact items:

  • microUSB to microUSB Extension Cable
  • IEC320 C7 Socket
  •  Ethernet Coupler
  • 8″ HDMI Extension
  • Right Angle microUSB Cable
  • microUSB Ethernet Adapter and USB Hub

Also needed were:

  • NES Gamepad Hookup PCB (more on this below)
  • M4-0.7 screws (10-16mm length)
  • Printed brackets (more on this below)
  • 16 AWG Wire
  • Female 2-prong socket end
  • Hot Glue
  • Quick Set Epoxy
  • Low Grit Sandpaper

Project details at Maniacal Labs project page.

This entry was posted on Wednesday, July 29th, 2015 at 10:00 pm and is filed under Arduino. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • gant: They still have a couple of the more expensive (but still considerably cheap) 5S-I-S01 in stock...
  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!