Categories

2.2 or 2.4 or 2.8 inch SPI TFT LCD ILI9341 to Arduino Uno

Posted on Tuesday, July 28th, 2015 in Arduino, Interface by DP

Arduino+to+2.8+LCD+schematic.bmp

Bob Davis  has written an article on interfacing a 2.8 inch SPI TFT LCD ILI9341 with the Arduino Uno:

Over the weekend I figured out how to interface a 2.8 inch SPI TFT that has a ILI9341 chip to an Arduino Uno.  All it takes is eight 1K resistors.  Most people use a 4050 IC.  Here is the schematic
I am using the Adafruit ILI9341 driver found at github
Note that the Adafruit LCD has level shifters for 5 volts built into it.

More details at Bob Davis’ blog.

Check out the video after the break.

This entry was posted on Tuesday, July 28th, 2015 at 4:23 pm and is filed under Arduino, Interface. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please