Categories

LiTiny- A Tiny LiIon charger for most things battery

Posted on Wednesday, July 1st, 2015 in DIY by DP

charging_in_progress

Rohit Gupta made this LiTiny project, a tiny LiIon charger:

In the end I had a LiIon charger capable of charging batteries @700mA restricted due to thermal dissipation limits of home made PCBs.

Project details at Rohit’s blog.

This entry was posted on Wednesday, July 1st, 2015 at 1:31 pm and is filed under DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “LiTiny- A Tiny LiIon charger for most things battery”

  1. Florian says:

    nice little Board!
    I started just like that and I am now selling them on Tindie:
    https://www.tindie.com/products/RFgermany/liponano-1/
    If you could do that too ^_^

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please