Categories

HP Agilent E3611A power supply teardown and calibration

Posted on Wednesday, May 6th, 2015 in power supply, Teardowns by DP

Florin of YourITronics did a teardown and calibration of a HP Agilent E3611A power supply:

I got this HP Agilent E3611A from Ebay. It was marked as not working and I was planing a repair video on it. Unfortunately the unit turned out to be fully functional so I only did a teardown and calibration.

This entry was posted on Wednesday, May 6th, 2015 at 2:42 pm and is filed under power supply, Teardowns. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please