Categories

Arduino-based inductance meter

Posted on Tuesday, December 16th, 2014 in Arduino, measurement by DP

mg_1131-600

Lukas of Soldernerd built a DIY Arduino-based inductance meter:

I’ve just finished a little Arduino project. It’s a shield for the Arduino Uno that lets you measure inductance. This is a functionality that I found missing in just about any digital multi meter. Yes, there are specialized LCR meters that let you measure inductance but they typically won’t measure voltages or currents. So I had to build my inductance meter myself.

Via the contact form.

This entry was posted on Tuesday, December 16th, 2014 at 1:18 pm and is filed under Arduino, measurement. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Arduino-based inductance meter”

  1. muslum alipour says:

    plase send detasheet diagram and hex file Arduino-based inductance meter thankyou

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please