Categories

First steps with the ESP8266-03 development board

Posted on Tuesday, December 9th, 2014 in dev boards by DP

esp8266_fun_m

As a follow up to the “Development board for the ESP8266-03” post, Limpkin blogged about his first steps with ESP8266-03 dev board:

As mentioned in my previous blog post I was very optimistic when designing my ESP8266-03 development board and didn’t even prototype it before launching a batch in production. As I just received a few of these boards in the mail today and given that information about this module is scattered all over the internet, I’ll detail here my first steps with it…

 

Check out the video after the break.

This entry was posted on Tuesday, December 9th, 2014 at 12:34 pm and is filed under dev boards. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “First steps with the ESP8266-03 development board”

  1. Xykon says:

    What is the transfer rate on these modules? As far as I could find out, these are used via UART? Does that mean they are limited to 115200bps minus the uart overhead?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please