Categories

ATX Breakout Board V1.1 Acrylic case back in stock

Posted on Tuesday, August 19th, 2014 in cases, News by DP

ATXBreakout Board case-W600

The ATX Breakout Board v1.1 Sick of Beige case is back in stock at Seeed Studio. This case is designed to be simple, cheap, and easy to assemble. The ATX Breakout Board is sandwiched between two laser-cut acrylic sheets, and the whole assembly is held together with aluminum screws and standoffs.

This is a minor update with the secondary ground and -5volt post holes cut, and a ventilation opening over the big resistor.

Check out our tutorial on how to customize Sick of Beige cases.

You can get one for $4 at Seeed Studio.

This entry was posted on Tuesday, August 19th, 2014 at 7:01 pm and is filed under cases, News. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please