Categories

ATTiny85 breakout board

Posted on Monday, June 30th, 2014 in project logs by DP

DSC_0186

Shady994 shared his first PCB an ATTiny85 breakout board in the project log forum:

I (badly!) soldered up my first PCB, an ATTiny85 programming/breakout board.
It also has a header so I can connect it to my Bus Pirate, which I’ve been using as a programmer.

This entry was posted on Monday, June 30th, 2014 at 1:00 pm and is filed under project logs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please