Categories

Using Bus Blaster + openOCD on OSX Mavericks

Posted on Wednesday, June 18th, 2014 in Bus Blaster by DP

Screen-Shot-2014-01-05-at-8.05.07-AM-640x362

Alvaro wrote an article on using a Bus Blaster + openOCD on OSX Mavericks:

I’ve been using the Dangerous Prototypes Bus Blaster along with openOCD to program/debug my LPC1769 microcontroller. It’s been a while since I did anything, so when I tried again last week and couldn’t get it to work, I was slightly confused. The only change (that I was aware of) was an OSX upgrade from Mountain Lion to Mavericks.

You can get a Bus Blaster v3 for $34.95.

This entry was posted on Wednesday, June 18th, 2014 at 11:00 am and is filed under Bus Blaster. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please