Categories

DIY CNC pendant

Posted on Friday, June 13th, 2014 in DIY, hacks by DP

DIY-CNC-Pendant

A DIY CNC pendant made by Bob Davis.  He wrote a post on his blog detailing it’s assembly:

Last night I finished building my DIY CNC pendant and tested it out.  I still need to add a manual jogger to it someday.  It is made out of an old Zenith TV remote control.  The key is to have three position toggle switches.  I have a lot of them laying around that were left over from another project.  You can build this for about $25 or for free in my case because I used parts that I had laying around.  It will be in my next book “Arduino CNC Projects”.

Via Hacked Gadgets.

Check out the video after the break.

This entry was posted on Friday, June 13th, 2014 at 7:00 pm and is filed under DIY, hacks. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please