Categories

Hantek PPS 2320A review

Posted on Friday, May 9th, 2014 in kit biz, power supply by DP

Hantek_PPS-2320A_7570

Alan Parekh of Hacked Gadgets writes:

Thanks to Circuit Specialists for sending in this 3 chanel power supply. The Hantek PPS 2320A sure packs in a ton of features for the price. The video below goes through the unboxing of the power supply and a quick run through its features. Overall it functions quite well, there are a few questions that need some clarification. I will have a look through the manual and reach out to the guys over at Circuit Specialists if I can’t find the answers.

Check out the video after the break.

“Specifications:

  • Number of Channels: 3
  • Maximum Output Voltage: 64 volts (32 volts Channel 1 & 32 volts Channel 2)
  • Fixed Channel 3: Adjustable from 2.5 volts, 3.3 volts and 5 volts at 0 to 3 amps
  • Modes: Constant Current ( c.c.) , Constant Voltage ( c.v.), Parallel, Serial, Split-Rail( negative and positive voltages)
  • Regulation ( CV): <0.1% =5mV (1,3A): <0.02% + 5mV (1>3A)
  • Regulation (CC): <0.02% +3 mA
  • Ripple and Noise (CV):<5mV RMS
  • Ripple and Noise (CC):<3mA RMS
  • AC input: 120VAC 60Hz/50Hz +/- 10% (USA style power cod
  • Rise Time ( output voltage) :<100ms with or without load present
  • Fall Time (output voltage) : < 100ms with or without load present
  • Display Accuracy (Voltage & Current): +/- 0.5% plus 2 words
  • Protection: OCP ( Overcurrent Portection), OVP (Over Voltage Protection)
  • Cooling: Thermostaticly controlled fan
  • Size: 8.6″ x 5.6″ x 13.6″ ( 215mm x 140mm x 340mm)
  • weight: 16lbs
  • Temperature for accurate Operation: 0- to 40 Deg Celsius
  • Humidity max for accurate operation: <80
  • 1 year limited warranty”

This entry was posted on Friday, May 9th, 2014 at 7:02 pm and is filed under kit biz, power supply. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please