Categories

Relay control board on DP5031 PCB

Posted on Tuesday, December 3rd, 2013 in project logs by DP

RB01-brd

Tom writes:

Here’s a breakout board for those Songle SRD series relays that are so cheap on Ebay. It fits nicely on the Dangerous Prototypes standard PCB size DP5031.
Electromechanical relays are generally employ small signals to switch much higher voltages and currents. As a result, a nice big gap is required to insulate between the signal and load sides. It’s often a good idea to hive relays off to a separate board.

Via the project log forum.

This entry was posted on Tuesday, December 3rd, 2013 at 11:00 am and is filed under project logs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • coppice: If all you have found so far is fake iphones, the next place you should visit is SEG in Hua Qiang Bei. Get out of...
  • Edward Cooper: Great article and good find on the markets! Any chance you can provide the locations of these places? I'm in Shenzhen at the moment and...
  • Dan: I'm up for one
  • TrickyNekro: Always in for another bunch! :-D
  • mol-1: Maybe this time !