Categories

POTONG6 – Potentiometer & Slide switch breakout

Posted on Thursday, November 28th, 2013 in project logs by DP

Potong6

Mats shared his Potentiometer & Slide switch breakout -POTONG6 in the project log forum:

This is just a small utility board that I added to a previous batch of PCBs. Nothing fancy at all. :-)
Sometimes I need a pot or two when I test a design on a solderless breadboard and it’s always a PITA to fit the pots into the breadboard, same thing with switches. So I made the POTONG6 that is a SOB DP8049-sized breakout board with six small (10x10mm) potentiometers and six small slide switches for easy connection to a breadboard.

Files available on Github.

This entry was posted on Thursday, November 28th, 2013 at 12:00 pm and is filed under project logs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please