Categories

ATX panel

Posted on Wednesday, July 17th, 2013 in ATX BB by DP

atx bob

Rynius writes:

Here’s my new mobile electronics bench featuring the ATX break out board. I’m hoping this will finally keep all my tools and wires consolidated and be pushed out of the way when needed.

I’m planning on setting up a nice solder station opposite the power supply. The variable one I have is a POS and either is too cool to melt the solder or heats up the handle and burns my hand. I have a nice drawer organizer for hacker tools in the works too.

Via the forum.

This entry was posted on Wednesday, July 17th, 2013 at 7:00 pm and is filed under ATX BB. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “ATX panel”

  1. drGspot says:

    …did you planned in v. 2.0 to make a regulation say from 0-12 V + …?
    … variable resistor or high power transistor…? maybe some regulating IC…

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Drone: So these go for around $330 USD and NO published calibration procedure online or otherwise? Given what's inside - I don't think I'll be considering...
  • Pekka Akselin: This is ridiculous!? :-) We are back at 256(!) byte EPROMs that needed multiple, a handful, of voltages to run! :-(
  • KH: Let's try a back-of-envelope calc balancing energies. From MCP1700 datasheet, there are graphs for a 200mA load step. Estimate the energy shortfall as 12uJ. Say...
  • Daniel: It's been a week and my comment is still awaiting moderation. Apparently the CIA doesn't want their involvement known?
  • KH: Agree, so okay, I guess he must have learned from somewhere. 100nF and 1000uF is so far apart, that was jarring; it's more magic incantation...