Categories

Minimal ECG using an Arduino and Xoscillo

Posted on Tuesday, July 9th, 2013 in Arduino by DP

heartbeat4

Raul  from Coding Laboratory has designed a DIY ECG project using an Arduino and Xoscillo:

To display the wave I am using XOSCILLO, a very cool and open source tool (which I wrote :P) that converts your Arduino into an oscilloscope.

This entry was posted on Tuesday, July 9th, 2013 at 7:00 pm and is filed under Arduino. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “Minimal ECG using an Arduino and Xoscillo”

  1. K Ram says:

    Really Great work .I would like to know more abbout this work

  2. Numan Celik says:

    Hi, how we can use or install this program then? We have some ECG results using with arduino and show it in like this tool.
    thanks

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please