Categories

App note: Protecting 1-wire 5V slaves from overvoltage

Posted on Sunday, June 16th, 2013 in app notes by DP

maxapp

Here is a tutorial from Maxim describing how to protect your 1-wire slave devices from overvoltage.

If an application requires writing to EPROM devices after deployment, 5V devices need to be protected from overvoltage exposure. This article explains how to have 1-Wire EPROMs and 5V 1-Wire devices on the same bus, if the 5V devices are protected from the programming pulse.

This entry was posted on Sunday, June 16th, 2013 at 10:00 pm and is filed under app notes. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: Whoa, some of the code this engineer writes... Just look at part one of the above blog post, see how he coded the 7-segment encodings...
  • Alan: You posted this right next to a bot that draws pictures... It seems logical to ask if there's a version that can draw.
  • mrx23dot: Hi, I'm selling the 2017 version http://www.ebay.com/itm/-/322425850293
  • Max: As a learning experience, sure. Once that's done, though....well...
  • samuel: have a nice week everyone