Categories

SMPS with battery backup and NiMH charger using the LM2595

Posted on Tuesday, April 2nd, 2013 in power supply by DP

SMPS_and_Battery_Backup_2-W600

Giorgos from PCBheaven designed an SMPS buck regulator with 2xAA NiMh battery trickle charger and power failure output:

Some time ago I presented a small circuit with the MCP1640, the High Efficiency Battery Boost Regulator using the MCP1640. My original intention was to combine it with this one and make a complete power supply unit with SMPS technology, dual voltage output, battery charger and power failure signal output. And here it is!

This entry was posted on Tuesday, April 2nd, 2013 at 9:00 pm and is filed under power supply. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please