DS1077 + Arduino


Wardy has documented his DS1077 configurable oscillator with the Arduino:

I’ve finally had a chance to get around to playing with the DS1077 configurable oscillator!

The circuit to get it working is very simple, just hook up the Ardiono as the I2C master, I used a 10K pullup resistor on both the SCL and SDA lines.  I tied CTR0 and CTR1 on the DS1077 to GND to enable the chip all the time.

Join the Conversation

1 Comment

Leave a comment

Your email address will not be published. Required fields are marked *

Notify me of followup comments via e-mail. You can also subscribe without commenting.