Categories

Workshop Update for February 21st, 2013

Posted on Thursday, February 21st, 2013 in Workshop Update by DP

breadbbb

Today we recorded and wrote up the earlier video post about the TM220A pick and place machine. We also worked on the 3D models for the Bus Pirate educational kit. The previous breadboard model was inaccurate, and too rough for our liking, so we designed one from the ground up (SketchUp screenshot above).

This entry was posted on Thursday, February 21st, 2013 at 11:00 pm and is filed under Workshop Update. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Max: Hey, good job quoting as an abstract something the author writes about someone else's project... For the record, I do appreciate the proper attention to...
  • imqqmi: Also interesting to note that arduino's use the DTR signal to reset the device. I found this out because repetier was able to do this...
  • Kevin: A bit sad that you are using a knock off Saleae device unless you are not using Saleae software.
  • Max: For the Haxxor Edition he could add a Morse-to-scan-code translator to the code in the PIC (where the L337 Haxxor Special also accepts Unicode code...
  • KH: Someone with a PIC16F1459 project, well you don't see these every day. Methinks he repeats the USB 2.0 thing too much; this might mislead people...