Workshop Update for February 20th, 2013

Posted on Wednesday, February 20th, 2013 in Workshop Update by DP


Workshoped a few part kit ideas. Mounted and reflowed the passives onto a Bus Pirate v4 with the TM220A. Will have a workshop video about it tomorrow.

We also designed a Sick of Beige test rig holder. It features holes for all sizes of Sick of Beige standard PCBs. Both square and golder rectangle shapes are supported. The lower left hole is the common denominator for golden rectangle boards, while the one next to it (right) is common for all square boards.

For $3 you can get a blank Sick of Beige template case for all our standard PCB sizes.

This entry was posted on Wednesday, February 20th, 2013 at 11:00 pm and is filed under Workshop Update. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Workshop Update for February 20th, 2013”

  1. kevin says:

    Good idea on the test rig holder :)

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Nathan Johnson: 100 channels. Not many are legal in any given area. Be sure to comply with local laws.
  • William Brodie-Tyrrell: It's getting to the point where it's cheaper and definitely easier to use a Pi Zero or similar and a $20 3G USB dongle. Power...
  • KH: IIRC most of the actual operating system of modern HDDs is in one of the platter(s); the stuff on the 25VF010 is a bootup firmware......
  • Trev: I don't know of any inexpensive 3G modules (prices start around $US 50), but it does explain why 2G modules are relatively inexpensive by comparison....
  • Zonie: This site Rocks!