Workshop Update for February 7th, 2013

Posted on Thursday, February 7th, 2013 in Workshop Update by DP


Today we recorded and edited the solder paste dispenser video.

Work continues on the Bus Pirate v4 UART debugging mode. We fixed yesterdays bug and after some code cleanup it will be committed into our SVN tomorrow. There will be two modes available. One is activated at compile and completely disconnects USB communication. While the other is accessed by sending command ‘q’ while in HiZ mode. This will enable parallel communication through both USB and UART.

This entry was posted on Thursday, February 7th, 2013 at 11:00 pm and is filed under Workshop Update. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Nathan Johnson: 100 channels. Not many are legal in any given area. Be sure to comply with local laws.
  • William Brodie-Tyrrell: It's getting to the point where it's cheaper and definitely easier to use a Pi Zero or similar and a $20 3G USB dongle. Power...
  • KH: IIRC most of the actual operating system of modern HDDs is in one of the platter(s); the stuff on the 25VF010 is a bootup firmware......
  • Trev: I don't know of any inexpensive 3G modules (prices start around $US 50), but it does explain why 2G modules are relatively inexpensive by comparison....
  • Zonie: This site Rocks!