Categories

Workshop Update for December 3rd, 2012

Posted on Monday, December 3rd, 2012 in Workshop Update by DP

In the workshop we’re cooking up new versions of our QFP protoboards. We’re migrating them to the standard DP10080 PCBs. Since the old boards were also designed to fit Eagle’s 100mmx80mm limit, we’re having difficulties fitting the new PCB restrictions. (keepouts and mounting holes)

This entry was posted on Monday, December 3rd, 2012 at 11:00 pm and is filed under Workshop Update. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Workshop Update for December 3rd, 2012”

  1. Jan says:

    I would say that it is time to move to Kicad for these boards – you will be otherwise constantly fighting the limits of the free version. Of course, the commercial version doesn’t have the limitations but that doesn’t help a lot for the open source designs …

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Edward Mallon: Like a great Hollywood franchise, I've finally put together the prequel - months after the I2C registers tutorial was released: https://edwardmallon.wordpress.com/2017/12/17/adding-sensors-to-an-arduino-data-logger/ This adds to the...
  • Drone: So these go for around $330 USD and NO published calibration procedure online or otherwise? Given what's inside - I don't think I'll be considering...
  • Pekka Akselin: This is ridiculous!? :-) We are back at 256(!) byte EPROMs that needed multiple, a handful, of voltages to run! :-(
  • KH: Let's try a back-of-envelope calc balancing energies. From MCP1700 datasheet, there are graphs for a 200mA load step. Estimate the energy shortfall as 12uJ. Say...
  • Daniel: It's been a week and my comment is still awaiting moderation. Apparently the CIA doesn't want their involvement known?