Categories

Integrate the ATX Breakout Board into your ATX PSU

Posted on Wednesday, October 31st, 2012 in #liveupdates, ATX BB by DP

This is one way to combine your ATX Breakout Board with a ATX PSU. Simply drill 4 small holes into the PSU, and attach your board onto it. We recommend using standoffs and the top acrylic sheet from our ATX Breakout Board acrylic case to enclose this design.

Get the ATX Breakout Board from Seeed for $14, and the acrylic case for $4.

This entry was posted on Wednesday, October 31st, 2012 at 5:00 pm and is filed under #liveupdates, ATX BB. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Integrate the ATX Breakout Board into your ATX PSU”

  1. RodLophus says:

    I thing It would be nice if the mounting holes on the ATX Breakout Board matched the ones on a standard 120x120mm ATX power supply fan, so one could attach it to the top of the supply over the fan, using some long screw with screw spacers.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Alan: Reminds me of "bug zappers" shaped like tennis racquet. Outer mesh is ground for human contact, inner mesh has high voltage. They typically run from...
  • KH: He had qualms about electrolytic cap leakage impacting sleep current. I think such leakage is very low and hard to measure using hobby equipment, so...
  • Mike: Love these! great source for makers!
  • KH: Is my eyes playing tricks on me or did he just use gobs and gobs of solder on the top side?
  • Doug: When do we find out the winner??