Categories

Bus Blaster free PCB build

Posted on Friday, September 28th, 2012 in builds by DP

Gege2b built a free Bus Blaster v1 PCB.This is the first prototype of the Bus Blaster that used fixed discrete logic to imitate a JTAGkey programmer type. The most recent Bus Blasters replace the fixed logic with a programmable CPLD logic chip so it can be upgraded to imitate many different programmers.

The Bus Blaster is a high-speed JTAG debugger for ARM processors, FPGAs, CPLDs, flash memory, and more.

If you build a free PCB we’ll send you another one! Blog about it, post a picture on Flickr, whatever – we’ll send you a coupon code for the free PCB drawer.

You can get a Bus Blaster v2 for $34.95.

This entry was posted on Friday, September 28th, 2012 at 7:00 pm and is filed under builds. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Max: Hey, good job quoting as an abstract something the author writes about someone else's project... For the record, I do appreciate the proper attention to...
  • imqqmi: Also interesting to note that arduino's use the DTR signal to reset the device. I found this out because repetier was able to do this...
  • Kevin: A bit sad that you are using a knock off Saleae device unless you are not using Saleae software.
  • Max: For the Haxxor Edition he could add a Morse-to-scan-code translator to the code in the PIC (where the L337 Haxxor Special also accepts Unicode code...
  • KH: Someone with a PIC16F1459 project, well you don't see these every day. Methinks he repeats the USB 2.0 thing too much; this might mislead people...