Categories

ATX Breakout board free PCB build

Posted on Wednesday, September 12th, 2012 in builds by DP

Schazamp built an ATX Breakout board free PCB. The ATX breakout board routes the -12, 3.3, 5 and 12 volt ATX outputs to screw terminals, each protected by a 1.25 amp resettable polyfuse.

Here’s my ATX breakout board assembly. I am not happy with the binding posts, but I had them from another project, and couldn’t find better ones here in town for less than $3 a pop, so I’ll wait until I can find a deal or have a mouser or digikey order to go out…

Thanks again Ian and Co. for the free PCBs!

If you build a free PCB we’ll send you another one! Blog about it, post a picture on Flicker, whatever – we’ll send you a coupon code for the free PCB drawer.

Available for $13.80 at Seeed Studio.

Via the forum.

This entry was posted on Wednesday, September 12th, 2012 at 9:00 pm and is filed under builds. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Bob: Jambalaya rocks.
  • KH: I should point out something... well, lead acid car batteries are designed to be well-charged all the time. The plates (which are patterned and thin)...
  • David Haile: You are a smart person and absolutely correct. That kind of current needs a lead acid car battery behind it. Still, it does have its...
  • KH: The solution discussed in the linked article is wrong. It's a largish Lipo (2500mAh) and he thinks 77uA is acceptable... ha ha ha ha ha....
  • Dave: I never had to opportunity to learn or use this stuff when I was in college (I'm sooo old that op-amps were just being developed...