Categories

App note: Tiny synchronous step-up converter design guide

Posted on Sunday, September 9th, 2012 in app notes by DP

Here is a design guide from Linear Technology describing how to design boost power supplies that can work from as little as 0.7 volts. These constant voltage power supplies that can run off until nearly every last drop of power is consumed.

This entry was posted on Sunday, September 9th, 2012 at 1:00 pm and is filed under app notes. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “App note: Tiny synchronous step-up converter design guide”

  1. KarlP says:

    For a similar part, but far far cheaper, parts like the MCP1623 and MCP1640 are just as fun

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: TPS62200 will get him to under 15uA, a bit better than the 20-30uA he mentioned. I would try the same thing. Switch some resistors in...
  • KH: Yeah, it's an end-user thing. Very few people would spend hundreds of hours on this kind of project and sustain it. It's more or less...
  • Max: Not quite a dinosaur if you've seen Big Hero 6 though... wait. You've watched it with your kids, didn't you? That's cheating...! ;) One of...
  • Edward Mallon: A visiting researcher dropped by our humble basement workshop with questions about the physical skill level students would need if they added one of our...
  • KH: And that looks really expensive... Only browsed the vid though, I'm an dinosaur so I had the sound off too. Nice of him to open-source...