Categories

ATX breakout board case prototype

Posted on Thursday, September 6th, 2012 in Workshop Update by Ian

image

Some quick shots of the atx case test fit number 2. Looks great. A few spacing tweaks and it goes to production.
image

image

Back side with some decorative cutting. The mouse holding it up is a nonstop source of loathing.

This entry was posted on Thursday, September 6th, 2012 at 8:40 am and is filed under Workshop Update. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “ATX breakout board case prototype”

  1. Sjaak says:

    Nice! it looks very clean!

    But why dont you use the standoff of the terminals itself?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Drone: So these go for around $330 USD and NO published calibration procedure online or otherwise? Given what's inside - I don't think I'll be considering...
  • Pekka Akselin: This is ridiculous!? :-) We are back at 256(!) byte EPROMs that needed multiple, a handful, of voltages to run! :-(
  • KH: Let's try a back-of-envelope calc balancing energies. From MCP1700 datasheet, there are graphs for a 200mA load step. Estimate the energy shortfall as 12uJ. Say...
  • Daniel: It's been a week and my comment is still awaiting moderation. Apparently the CIA doesn't want their involvement known?
  • KH: Agree, so okay, I guess he must have learned from somewhere. 100nF and 1000uF is so far apart, that was jarring; it's more magic incantation...