Categories

App note: Switch mode regulators for battery powered systems

Posted on Saturday, September 1st, 2012 in app notes by DP

Maxim describes various SMPS regulator topologies for battery powered systems. Isolated and non-isolated topologies are covered:

This tutorial presents an overview of regulator topologies for battery-powered equipment. The discussion covers linear regulators, charge pumps, buck and boost regulators, inverters, and flyback designs. The importance of peak current is explained, and schematics of each topology are shown.

This entry was posted on Saturday, September 1st, 2012 at 9:00 pm and is filed under app notes. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Dave B: Got two of them. If you let the battery run flat, they don't charge! You have to pull the battery, and get enough charge in...
  • Bill F: My turn?
  • Chris: Ok!
  • Bob: Free PCB for me!
  • Blars: Yet another meaningless comment.