Categories

Temperature and relative humidity logger with the chipKIT Uno32

Posted on Wednesday, August 22nd, 2012 in dev boards, how-to by DP

Here is another chipKIT Uno32 tutorial on a PC-based temperature, and humidity logger. The examples are simple enough for electronics novices to get started.

This project is about building a PC-based temperature and relative humidity logger using the chipKIT Uno32 board and the DHT11 sensor. The project setup requires no additional wires (other than the USB cable) and components; the DHT11 sensor is directly plugged into four I/O pins of the Uno32 board and the project is ready to go.

This entry was posted on Wednesday, August 22nd, 2012 at 9:00 pm and is filed under dev boards, how-to. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Alex Lao: Wow, I didn't expect to be featured on here! It's an honor.
  • Inyaki: Hi, Would you si king to point me the corsair's single 12v rail supplies? I am interested on it but I can't find it.....
  • peter: In the middle of the geek reading I get a tweet. Here I am
  • icserny: Unfortunately the DIY PCB homepage.is no longer available. Something happened...
  • Lukas: Yes, that's also how I do it, use an extension cable or ar least a 'spacer', i.e. a male and female header soldered directly together....