Categories

Arduino Robot shield

Posted on Wednesday, August 1st, 2012 in Arduino, robotics by DP

This is an Arduino shield intended for robotics prototyping. It features a DC/DC power supply, a sonar obstacle sensor, and a IR remote control receiver.

The idea behind this post is to bring together some robot designs and trasform them in a new device with new hardware and standard software (arduino of course) and so easier use.

This entry was posted on Wednesday, August 1st, 2012 at 9:00 pm and is filed under Arduino, robotics. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Arduino Robot shield”

  1. Wayne Mayer says:

    I am working on just such a project right now! I am enjoying my Arduino Mega 2560. This shield would truly be a God-send!

    Wayne Mayer

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Daniel: Do I comment here or on FB?
  • Craig B: Shouldn't the default be 00xxx010? Note that bit 0 appears out of order in the documentation. In that case I think the initial value is...
  • JJM: From the datasheet extract you are showing, the power up status should be 00xxx010, not 000xxx01. Bit numbering is misleading since 'measurement resolution' is apparently...
  • Jan Ciger (@janoc200): Hmm, that could actually explain why the three sensor IMU breakout I have bought a few years ago had all sorts of issues - I...
  • Travis: Is it preset to the windows 3 fingered salute?