Categories

DIY programming pogo pins

Posted on Tuesday, July 3rd, 2012 in DIY by DP

Menno posted a bunch of links with various ideas for building DIY programming pogo-pins. This tool is handy for programming a batch of boards without attaching a header.We especially liked the idea above, it seems simple and very robust. Check out other ideas below the fold.

Connection springs from an Ethernet cable header.

Perf-board, and spring loaded sawing safety pins.

Via the forum. Thanks Menno.

This entry was posted on Tuesday, July 3rd, 2012 at 11:00 am and is filed under DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please