Bus Blaster free PCB built

Posted on Wednesday, April 18th, 2012 in builds by DP

Muralidhar Shenoy blogged about his free Bus Blaster v3 PCB build, a high-speed JTAG debugger for ARM processors, FPGAs, CPLDs, flash, and more. Version 3 is a small update to v2/v2.5 with symmetrical connector placement to make it fit a case.

If you build a free PCB we’ll send you another one! Blog about it, post a picture on Flicker, whatever – we’ll send you a coupon code for the free PCB drawer.

You can get a Bus Blaster v2 for $34.95.

This entry was posted on Wednesday, April 18th, 2012 at 11:00 pm and is filed under builds. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Nathan Johnson: 100 channels. Not many are legal in any given area. Be sure to comply with local laws.
  • William Brodie-Tyrrell: It's getting to the point where it's cheaper and definitely easier to use a Pi Zero or similar and a $20 3G USB dongle. Power...
  • KH: IIRC most of the actual operating system of modern HDDs is in one of the platter(s); the stuff on the 25VF010 is a bootup firmware......
  • Trev: I don't know of any inexpensive 3G modules (prices start around $US 50), but it does explain why 2G modules are relatively inexpensive by comparison....
  • Zonie: This site Rocks!