Categories

Bus Blaster v4 free PCB build

Posted on Tuesday, April 10th, 2012 in builds, Bus Blaster by DP

Skot built a free Bus Blaster v3 v4 PCB, a high-speed JTAG debugger for ARM processors, FPGAs, CPLDs, flash, and more. v3 v4 is a small update to v2/v2.5 with symmetrical connector placement to make it fit a case.

If you build a free PCB we’ll send you another one! Blog about it, post a picture on Flicker, whatever – we’ll send you a coupon code for the free PCB drawer.

You can get a Bus Blaster v2 for $34.95.

This entry was posted on Tuesday, April 10th, 2012 at 11:00 am and is filed under builds, Bus Blaster. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “Bus Blaster v4 free PCB build”

  1. Skot built a free Bus Blaster v3 PCBIt was a 4.0 PCB (see in the photo), not a v3 PCB.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Edward Mallon: A teacher friend asked us for faster build that was less dependent on soldering because they didn't have the budget for that kit. So we've...
  • lostengineer: hahaha an entire article just saying to heat-shrink your wires or glue them if they might move around a lot. When did common sense die?
  • readybrek: They're tasty tasty very very tasty... they're very tasty.
  • hli: Sunday++
  • Chamod: Check on your buddy. Make sure they don't forget their lunchbox.