Categories

Contiki 2.5 running on the Web Platform

Posted on Monday, January 23rd, 2012 in Development, firmware by DP

Shuckc has successfully ported the Contiki 2.5 OS to the Web Platform. Contiki is an open source operating system for embedded devices. It supports both IPv4 and IPv6 internet protocols, and is not too taxing on memory, usually taking around 40KB of ROM and a few K of RAM.

As I hinted last week (and at least one sleuth tracked down on GitHub) I’ve ported Contiki OS 2.5 to run on the WebPlatform board. The port consists of a new cpu “dspic” using the pic30 Microchip/gcc toolchain and a new platform “dp-webplatform” for Ians board.

Via the forum. Thanks Shuckc.

This entry was posted on Monday, January 23rd, 2012 at 3:00 pm and is filed under Development, firmware. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “Contiki 2.5 running on the Web Platform”

  1. Bo :o) says:

    Thanx !

    This takes the web platform to a new level !. Being busy this week, I can’t hardly wait until the weekend when I have some time to play around with this.

    Bo :o)

  2. Drone says:

    Cool, could this be used to make a NTP server out of the Web Server?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Craig B: Shouldn't the default be 00xxx010? Note that bit 0 appears out of order in the documentation. In that case I think the initial value is...
  • JJM: From the datasheet extract you are showing, the power up status should be 00xxx010, not 000xxx01. Bit numbering is misleading since 'measurement resolution' is apparently...
  • Jan Ciger (@janoc200): Hmm, that could actually explain why the three sensor IMU breakout I have bought a few years ago had all sorts of issues - I...
  • Travis: Is it preset to the windows 3 fingered salute?
  • Glenn: What a cool idea !