Categories

Nomis: Simon game clone on ATTiny85

Posted on Wednesday, January 11th, 2012 in AVR, DIY by the machinegeek


Christopher Woodall from HappyRobotLabs wrote in about his recent project, Nomis, a Simon clone made using an ATTiny85.

It uses up 4 pins, 3 for LEDs and 1 for buttons (ADC input). The write up can be found here. Everything is completely open source (except for the EAGLE CAD limitations of course, which kind of suck) and I am currently waiting on some PCBs to be made.

The source code can be found on the project’s Github page, and there are additional photos on Flickr.

This entry was posted on Wednesday, January 11th, 2012 at 5:00 pm and is filed under AVR, DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please