Categories

DIY Santa Claus Singer with Flyport

Posted on Friday, December 23rd, 2011 in DIY, Holiday, project logs by the machinegeek


Stefano has completed work on a holiday project known as the DIY Santa Claus Singer with Flyport. It is built around an animated Santa Claus decoration with the control switch bypassed with an NPN transistor. The switch is controlled over the internet via the Arduino/ethernet shield combo which responds to Twitter messages.

Part one of his article containing mainly the project announcement can be found here.

The second part of the project description containing more details as well as the code can be found here.

Via HackedGadgets.

This entry was posted on Friday, December 23rd, 2011 at 5:00 pm and is filed under DIY, Holiday, project logs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please