Categories

Little Wire – minimal AVR programmer and more

Posted on Friday, December 9th, 2011 in DIY by DP

The Little Wire is an open source AVR programmer that’s packed full of features:

  • An AVR programer
  • Four digital GPIO pins
  • ADC with 10 bit resolution
  • Two parallel hardware PWM outputs
  • An USB interface
  • A SPI interface

It is built to be DIY friendly by using all through hole components. It is also an open source hardware project, and different versions are already popping up in the forum.

Via the forum.

This entry was posted on Friday, December 9th, 2011 at 8:00 pm and is filed under DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

5 Responses to “Little Wire – minimal AVR programmer and more”

  1. kmmankad says:

    smd smd smd! Tiny is cooler :-)

  2. Drone says:

    This can NOT program HVSP (fuses). Right?

  3. Hi Drone,

    This programmer CAN burn fuses, but it can NOT act as a High Voltage Programmer.

    ihsan.

  4. Drone says:

    I don’t think it can change all fuses. For example, I seem to remember you must use HVSP to re-purpose the RESET pin on the likes of the ATtiny45/85.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Paul Robertson: Count me in
  • Chris Jennings: I too like the cold and snow (it means no grass mowing). Now I can focus on fun stuff like hobby boards and woodworking.
  • flubba86: Commenting for fun and profit.
  • Sohan: If wishes were PCBs, beggars would be soldering!
  • Luke: Neat