Categories

Arduino controlled flamethrowing Jack-O’-Lantern

Posted on Monday, October 31st, 2011 in Arduino, Holiday, how-to by the machinegeek


Randofo published the details on this flamethrowing Jack-O’-Lantern on Instructables. This bad boy is designed for remote control via Squidbee RF modules so you can shoot a one-second burst of flame on command. (As randofo observes, you should be able to substitute any Arduino/XBee combo for the SquidBee.)

This definitely qualifies as a Dangerous (Halloween) Prototype!

Get all the build details and the Arduino sketch at Instructables.

Happy Halloween!

This entry was posted on Monday, October 31st, 2011 at 12:56 pm and is filed under Arduino, Holiday, how-to. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Edward Mallon: Like a great Hollywood franchise, I've finally put together the prequel - months after the I2C registers tutorial was released: https://edwardmallon.wordpress.com/2017/12/17/adding-sensors-to-an-arduino-data-logger/ This adds to the...
  • Drone: So these go for around $330 USD and NO published calibration procedure online or otherwise? Given what's inside - I don't think I'll be considering...
  • Pekka Akselin: This is ridiculous!? :-) We are back at 256(!) byte EPROMs that needed multiple, a handful, of voltages to run! :-(
  • KH: Let's try a back-of-envelope calc balancing energies. From MCP1700 datasheet, there are graphs for a 200mA load step. Estimate the energy shortfall as 12uJ. Say...
  • Daniel: It's been a week and my comment is still awaiting moderation. Apparently the CIA doesn't want their involvement known?