Categories

Arduino sound-responsive Halloween skull

Posted on Thursday, October 27th, 2011 in Arduino, code, Holiday, sensors by the machinegeek

Boris presents this project just in time for Halloween. It’s a simple Halloween skull which employs an Arduino to read the level from sound sensors and controls a servo connected to the skull’s mandible. You can see more project details and get the source code from the Open-Electronics website.

Via the contact form.

This entry was posted on Thursday, October 27th, 2011 at 2:57 pm and is filed under Arduino, code, Holiday, sensors. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: Yes, obviously I have read that. Here I am just curious, I am not saying the decision is wrong or hobbyists should not do this...
  • Concretedog: Hey... On the blog I explain... They are primarily for going into model rockets as payload hence the form factor.
  • KH: Okay I'm just too dense, but are there any technical reason(s) for the round shape? 15mm is big enough for a square board with a...
  • KH: One potential trouble point is, if you go into indoor farming in a big way, then the cops who use infrared cameras will go aha!...
  • Glendon: All your Free PCBs belong to me😎