Soldering iron tip selection guide from Hakko

Posted on Friday, October 14th, 2011 in tools by DP

Arhi contacted us about this useful guide for selecting the right size and shape tip for your soldering iron. First part of the article compares various diameter tips used over the same soldering point. Graphs show that for the fastest work-flow is when using larger or same size tips as the solder point.

The second part of the article compares different shaped tips with the same diameter. It is shown that tips with lager mass, transfer the heat better.

Via the contact form.

This entry was posted on Friday, October 14th, 2011 at 10:00 am and is filed under tools. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Nathan Johnson: 100 channels. Not many are legal in any given area. Be sure to comply with local laws.
  • William Brodie-Tyrrell: It's getting to the point where it's cheaper and definitely easier to use a Pi Zero or similar and a $20 3G USB dongle. Power...
  • KH: IIRC most of the actual operating system of modern HDDs is in one of the platter(s); the stuff on the 25VF010 is a bootup firmware......
  • Trev: I don't know of any inexpensive 3G modules (prices start around $US 50), but it does explain why 2G modules are relatively inexpensive by comparison....
  • Zonie: This site Rocks!