Categories

MSPism: Nordic 2.4 + MSP/MSP mini battery board

Posted on Monday, October 3rd, 2011 in Chips, dev boards, MSP430 by Ian

Brian shared a MSP + ISM radio design with onboard battery.

It was designed to work with this module. It uses  MSP430G2553 mcu in conjunction with the Nordic nRF24L01+ 2.4GHz transceiver chip. The design also incorporates headers compatible with Digi XBee radio and a CR1225 battery holder.Tthe programing of the chip can be done from the LaunchPad or using a FTDI basic uart header. The design has all you need for a embedded wireless project.

Via the forum.

This entry was posted on Monday, October 3rd, 2011 at 6:30 pm and is filed under Chips, dev boards, MSP430. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

9 Responses to “MSPism: Nordic 2.4 + MSP/MSP mini battery board”

  1. Brian says:

    For what is is worth this board is due for a revision and will not have the coin cell on the back in the final version. It will have a LiPo connector in place of it.

  2. Brian says:

    I assume you are referencing samples? I get samples for prototypes… Yes I do buy parts for production? Maybe I missed the joke.

    • Ian says:

      I thought you were in the prototyping stage. Obviously even if you are in the prototyping stage you still need to confirm they are available for production versions.

      • Brian says:

        There were order-able with a lead time of about 8 week. During part selection and a similar part was available as samples. I ordered samples, once the prototype worked I ordered the parts for the first production run, which haven’t gotten here yet.

  3. Remorilla says:

    Anybody has tested the range of the nRF24L01+ modules??

    • Brian says:

      I measured it at at least 20 meters for the modules I was using. In a not very harsh RF environment. There was quite a lot of dielectric material in the way also. I will test line of sight outside sometime.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • DP.: fixed, thanks
  • Bovine: Title of article has the wrong number for ESP8266 typed.
  • burkm m: It drifting even further using that standard XO...
  • langwadt: a HC14 is a bad choice for an xtal oscillator, the unbuffered non-Schmitt trigger HCU04 is much better for that application
  • Bill F: I'm ready for one!