USB Infrared Toy as a JTAG programmer

Posted on Friday, July 22nd, 2011 in Infrared toy, JTAG by Ian

electronicia4u used a USB Infrared Toy as a JTAG programmer:

After seeing circuit details I discovered it used some pic18F2550 as was almost compatible with  dangerousprotypes IR Infrared Toy (also they used same xtal frequency), so I downloaded firmware and programmed succesfully this device easily without modifiying firmware source code.

You can get IR Toy v2 for $22.05, including world wide shipping.

This entry was posted on Friday, July 22nd, 2011 at 2:00 pm and is filed under Infrared toy, JTAG. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

No Responses to “USB Infrared Toy as a JTAG programmer”

  1. Habibur Rahman says:

    please give me JTAG programmer circuit diagram & driver+burning software

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Stephen Tinius: Thank you.
  • KH: Ah, the site sells boards, that's the reason. At least it's a XC6SL9 board that does not cost an arm and a leg, though it...
  • Max: While I understand this is more educational than practical in nature, I prefer my edutainment a lot more firmly grounded in economic reality. Sure, you...
  • KH: Using an alkaline coin cell down to 1.0V or under is a very bad idea anyway, unless you as the designer or manufacturer don't care...
  • KH: Farnell says TS1001 is no longer stocked. Not on RS. Digikey says it's obsolete. That said, there are a lot of nanoamp-class parts on sale...